Recent content by aramtch

Great - thanks for your reply! With a sprinkler pump, would the installed pressure tank address the pressure issue? Or would it not even be able to fill the pressure tank past a certain PSI?

We have a 2 inch well that servies both our sprinkler system AND our home. The depth to water in my well is about 12'. I have a 60' horizontal run from the well to where my pump is - which sits about another 1 foot above the ground. Then our pump is hooked up to a pressure tank. I was able...

you're probably right. I'll be testing that this week - is there a recommended way of testing if there's a suction leak? Attach a pressure guage and see if it goes down over time?

OK guys, i connected the pump directly into the well (bypassing the 60' run) and it seems to pump water just fine. But if i move the pump back to where it needs to go, I'll end up with the same problem. So that's semi-good news. Just now I'm not sure what's the best way to proceed. Should...

Hey guys... i'm gonna try tomorrow to connect directly to the well - bypassing the horizontal run. I'll report back how that goes. Meanwhile, would the fact it's a 2" well (as opposed to a 1 1/4" or 1 1/2") make a big difference? (seems like it would) And would the fact i have nothing...

I've just had a new 2" well drilled and am trying to hook up to it a new 1HP shallow well jet pump. The depth to water in my well is about 20-24', but I have a 60' horizontal run from the well to where my pump is. In that horizontal run, I gradually decreased the size of the pipe, starting...

ok... how about the 2nd one down - here: http://tinyurl.com/2m23cz

Thanks bob... what about here (****): http://tinyurl.com/2q46vm

fine, beer it will be. You gotta love the "can-do" attitude on this board! So I guess I'm on the lookout for a railroad spike puller?

dangit bob - that was a lot of sledgehammering! :o OK then... well lets see - what options do I have? I suppose if there was a way I could pull the 25' of pipe out of the ground, I could replace the well point and hammer everything back into the same spot. Anyone have any ideas on how to...

Good morning Bob - I bought the well point at a place called Affron supply - its a local plumbing/irrigation place. I told them exactly what I wanted to do and they sold me the well point and cut/threaded my the pipe for me. The well point was 1.25", 3' long, and had holes about the size of...

Hey Sammy... I did (and am still) developing the well. However, I'm using the electric pump and not the hand pump (too tiring - esp after sledgehammering all day). What I did is: I have a cap that I use to cover part of the pipe when pump is pumping... once I get a decent flow of water, I...

(yes, galvanized... sorry Bob) UPDATE: I hammered down another 5 feet or so, so I'm now at about 24 feet (which includes the length of the 3' well point). I'm thinking that I'm probably at the right depth. So I now turn to the issue of water pressure... I haven't been able to do a super...

great - I'll measure today. And Bob thanks for the peace of mind, i should be able to go several feet deeper and not have to worry about the sulfur, etc. I'll probably continue hammering down in increments of 3 feet, and keep testing. Will keep you posted - you guys' help and advice is...

Thanks - but how do I measure how many feet of water is over the screen? Plus, some people around here have dug their wells too deep and hit sulfur and/or iron. So I don't want to go too deep - I'd rather err on the side of caution. Thoughts?