Catching both sinks in double vanity

Users who are viewing this thread

Dmt78

Member
Messages
70
Reaction score
3
Points
8
Location
Louisiana
I’m trying to set up drain and vent for double vanity in bathroom. Code is IPC. The end of the vanity will be where the 2x4 is laying at the bottom left corner of photo. The drain comes up almost directly where the left sink will fall. The fitting is not glued yet. Best way to handle this?
I found the second photo on the forums from Terry. Would this be my best bet?
This vent is for the whole bathroom.
ECAF3565-5C31-4B78-BA43-F828638E42D9.jpeg


BE6C1797-486F-48A1-8E6D-51366BA65D33.jpeg
 

wwhitney

In the Trades
Messages
6,532
Reaction score
1,822
Points
113
Location
Berkeley, CA
Yes, that works for the IPC. The top san-tee could be a street fitting.

Cheers, Wayne
 

Dmt78

Member
Messages
70
Reaction score
3
Points
8
Location
Louisiana
Yes, that works for the IPC. The top san-tee could be a street fitting.

Cheers, Wayne
So this shouldn’t cause any siphoning of the p traps correct? This main pipe is 2” and I’ll switch to 1 1/2” out of the stub outs.
 

wwhitney

In the Trades
Messages
6,532
Reaction score
1,822
Points
113
Location
Berkeley, CA
It's an allowable vertical wet vent, and with 2" on the vertical there's no issue.

Cheers, Wayne
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks