DougB
Member
I found it very difficult to find any info about how to install the Schluter profiles. Like how do you hold them in place, etc.
The reason to use 'some' Schluter is that if the tile has bull nose - I've found it to be 3" wide - looks like shit around a door or a corner. I used the bullnose around shower niches, but on the corners (3 or them) the Schluter really looks superior - IMO.
Well here's what I did. First I wanna tell you that I did not attend any stinkinnng 3 day workshop - I'm an engineer (electrical) so why would I need any stinkinnng Schluter workshop. Electricity, tile, just about the same...
Two methods: I've used hot gule - seems to hold it in place. Second was to use small pieces of plywood - and clamped it in place - this method works really nice. The main thing is that you want one of corners set - so don't do it until the next day!
The reason to use 'some' Schluter is that if the tile has bull nose - I've found it to be 3" wide - looks like shit around a door or a corner. I used the bullnose around shower niches, but on the corners (3 or them) the Schluter really looks superior - IMO.
Well here's what I did. First I wanna tell you that I did not attend any stinkinnng 3 day workshop - I'm an engineer (electrical) so why would I need any stinkinnng Schluter workshop. Electricity, tile, just about the same...
Two methods: I've used hot gule - seems to hold it in place. Second was to use small pieces of plywood - and clamped it in place - this method works really nice. The main thing is that you want one of corners set - so don't do it until the next day!