Re: Basement in floor plumbing - how many bends??
Posted by ED on May 18, 2004 at 20:07:15:
In response to Re: Basement in floor plumbing - how many bends??
Third time's a charm right?

Stick to plumbing and not the computer.

I AM JUST KIDDING!!!!

I just wanted to add that since the poster is laying out his lines before the slab is poured,
be sure and add drains and vent for a future basement bath, if you have not already planned to do so. A whole lot easier and cheaper NOW than later. (He may be just laying out the drains for the stacks at this moment.)


: : I am laying out the drain and vent lines in our basement before the basement floor is poured. I was told by the plumbing inspector that the drains could not have a 90 degree bend. I have two lines that will require 2 45 degree bends about 6 feet apart to get around a large pad that has already been poured. Is that OK and is there any limit to how many 45's you can have in a drain line?

: Your inspector said no 90 Degee bends?

: Ask HER what is a lead bend considered?

: Also if "drains" can't have a 90 degree angle WE had better never tell her that a trap is 180 degrees and thus doubly illegal is that what she is saying?

: I would try to get another inspectors opinion who is not PMS that day.

: I can understand no 1/4 bends or short sweeeps BUT to say no 90 degree angle something is wrong.




Replies to this post
There are none.