Amtrol wired for priority?
Posted by Denis on December 10, 2003 at 13:28:04:
I had a new furnace and Amtrol hot water heater installed a little over a year ago. The setup is controlled by a TACO 6 zone controller with the zone 6 priority option.

The Amtrol is currently wired so that the heating zones can demand at the same time as the hot water which can be a bad combination if a couple of heating zones start demanding right when someone is taking a shower. Zone 6 is available so I would like to rewire the Amtrol to zone 6 but cannot find instructions or a diagram. I have the TACO diagram and am somewhat familiar with zone contollers but not with the indirect hot water heater wiring.

Has anyone out there done this?

Thanks...

Does anyone have any


Replies to this post