Re: Cast Iron Hub Fitting with 3.12 ID Hub
Posted by Matt Leahy on June 01, 2002 at 23:14:13:
In response to Re: Cast Iron Hub Fitting with 3.12 ID Hub
: Matt,
: Have you "tried" it yet?
: My experience with them, is that the 2" ABS expands the rubber seal when inserted to full depth.
: I round the end of the pipe with a knife and use soft soap for lube.


The seal kind of fits when the pipe is installed, but it is still loose. If I push the pipe and seal in all the way (pushing the seal flange into the hub) it fills the gap, but it really doesn't hold the pipe as securley as I would like.

Replies to this post