|Posted by Brian Fuchs on February 12, 19100 at 13:56:20:|
I am getting ready to install marble tile in my bathroom (over a bare concrete slab).
When I lay the marble next to my toilet flange, they are flush (so to speak).
I figure that after the thinset, the flange will be about 1/8" below the tile.
Is this as bad as I think it is?
I've seen wax rings with plastic flanges imbeded in them.
If I need to have the flange raised, is there a spacer?
The last thing I want to do is replace the flange.
|Replies to this post|