New boiler, loop and with tuning
Posted by Daniel H. Weise on October 23, 19100 at 10:35:44:
Hi everyone
I love this site! I set up a new boiler and hot water heater in a new location as a direct vent, ran a new copper heat loop and found some beautiful old radiators to complete the system. I get wonderful heat and the house is finally cozy. I'm just curious as to the temperature and pressure I should run the system at. I was running a bit cool to start because I do have a couple kick space heaters in my kitchen that were not going on so I cranked it up. I am right now at a upper temp of 170 deg and a pressure of 20 pounds. Any advice would be appreciated.

Replies to this post
There are none.