Which fitting assemblies for Clack WS1

Discussion in 'Water Softener Forum, problems, installation and r' started by ohdannyboy72, Jul 13, 2014.

  1. ohdannyboy72

    ohdannyboy72 New Member

    Messages:
    2
    I'm going to install a clack WS1 into my home. The water service in my house is 3/4 inch copper pipe. Which fitting assemblies will I need to make the proper connections for this water softener? I see a 3/4 inch brass sweat ring. Is this my best option?
  2. Tom Sawyer

    Tom Sawyer In the Trades

    Messages:
    3,227
    Location:
    Maine
    Don't know without seeing your water service. If it's copper, a couple male adapters.
  3. ditttohead

    ditttohead Water systems designer, R&D

    Messages:
    1,860
    Location:
    Ontario California

Share This Page