washington state exam

Discussion in 'Plumbing Forum, Professional & DIY Advice, Tips & ' started by prospector, Jun 15, 2011.

  1. prospector

    prospector New Member

    Messages:
    2
    Location:
    washington state
    I took the state exam and failed it on the DWV & Water sizing.I've been a plumber for 25 years in Ca.I knew I was a little rusty on my sizing so I bought a 2009 code book.I studied the sizing pretty good and scored less than 50% on both sizing drawings.My problem is I was finding the answers on the straight runs ok,when I turned the corners 1 Hose bibb was added,then I couldn't find anything close on my answer sheet.According to the answer sheet the H/B was counted as 10 or more units,which threw off everything else off on the test,.I made a complaint but L&I never got back,I asked them to check the exam and I'm getting no response.Has this happened to any one else?I would really appreciate some advise thank you.
Similar Threads: washington state
Forum Title Date
Plumbing Forum, Professional & DIY Advice, Tips & Need a powerful tankless/Washington DC Jan 2, 2008
Plumbing Forum, Professional & DIY Advice, Tips & Need Advice Please Water Softener/Condenstate Drain Backup Issue Feb 1, 2014
Plumbing Forum, Professional & DIY Advice, Tips & Culligan Estate 2 Softener - Is it working? Nov 30, 2013
Plumbing Forum, Professional & DIY Advice, Tips & Barbed PE fitting in WA state (indoors) Apr 30, 2011
Plumbing Forum, Professional & DIY Advice, Tips & New State Water Heater Leaking Dec 10, 2010

Share This Page