underslab bathroom

Discussion in 'Plumbing Forum, Professional & DIY Advice, Tips & ' started by piper2, Apr 4, 2009.

  1. piper2

    piper2 New Member

    Messages:
    8
    Hi guys, need some info or run by u guys my plan for an add on for a single bath and kitchen sink. Ill start at end of run- 3" vtr w. 3" vent ell,3x1.5 wye on horz. to 1.5" trap for tub,3x2 wye on hrz. for 2" floor drn. w. trap,3x3 wye w. 1/8 bend on hrz. to 3"ell up to wc,3x2 sant. tee vert. for washer sp,3x2 sant tee vert. for lav.,about 14 feet down stream back to back 1/8 bends to offset drain to get 3x1.5" sant tee vert. in block wall to catch kitchen sink drain and 1.5" vtr . All on 1/4" pf slope out wall to 3x4 red. to 4" main co in front yard about 4' from front wall.My diggers dug my ditch all 17" deep and trap weir to top of slab will be 20",looks like my lav. vent will be about 6'3" from my 3"vtr,this is my concern.Its my first underslab job and I only get one shot so I dont want to cover it or call inspector until im sure. Any help???
  2. hj

    hj Moderator & Master Plumber Staff Member

    Messages:
    26,539
    Location:
    Cave Creek, Arizona
    Dwv

    If we wanted to take the time to draw out what we think you are describing, we might still get it wrong. Give us a drawing of the room, with the fixture locations and the way you want to install the piping, along with vent locations. Then MAYBE, we will be able to give some advice.
  3. piper2

    piper2 New Member

    Messages:
    8
    ok, thanks
Similar Threads: underslab bathroom
Forum Title Date
Plumbing Forum, Professional & DIY Advice, Tips & Properly venting a toilet underslab, help please! Jun 25, 2014
Plumbing Forum, Professional & DIY Advice, Tips & Cleanout and underslab bath drains Aug 27, 2012
Plumbing Forum, Professional & DIY Advice, Tips & Venting for 16' underslab drain May 19, 2008
Plumbing Forum, Professional & DIY Advice, Tips & Underslab DWV May 17, 2007
Plumbing Forum, Professional & DIY Advice, Tips & Stacked bathrooms Saturday at 10:02 AM

Share This Page