Two wells to one storage tank

[MarkMCM]

I have had one well running a cyclesensor and pumping to a storage tank with a float switch for cutoff when full.

I have added a second well pumping to the same storage tank. I would like to alternate pumps when one hits a dry cycle. All wiring to both wells is centralized.

 

[Valveman]

Just use two Cycle Sensors and two float switches set a few inches in height different from each other. On the pump with the highest float switch set the time delay in the Cycle Sensor for a long period of time. While that one is timing out, the tank level will lower and turn on the second pump for a while.

 

[Sponsor]

 

[MarkMCM]

Thanks. I will check to make sure I have an unused switch wire from the tank.