Toilet rough in questions

Discussion in 'Toilet Forum discussions' started by burnttoast77, Jun 17, 2013.

  1. burnttoast77

    burnttoast77 New Member

    Messages:
    4
    Location:
    Savannah, GA
    Hey all, fresh newb here in Savannah, GA.

    Here is my plan to rough in my toilet:

    Flange connected to:
    14" long piece of 3" PVC to:
    3" 90 long sweep elbow or closet flange to:
    3" sanitary tee.

    Lower part of San tee to:
    5" long piece of 3" PVC to:
    3" 45 elbow to:
    3" wye on side, clean-out on one side to:
    3"x4"x4" wye hooked up to the cast iron horizontal drain line

    And just realized it'd be way better to draw it. I'll try and get that done. I am mainly concerned about the drop right under the toilet flange. I need it to connect the tub waste line above the toilet San tee just wanted to make sure it was kosher.
    Last edited: Jun 17, 2013
  2. burnttoast77

    burnttoast77 New Member

    Messages:
    4
    Location:
    Savannah, GA
    IMG_20130617_215419_988.jpg

    Here it is, kinda, lol.

    And I have the shower vent and lav vent connect at the way top of this stack. so each fixture has its own vent.
  3. Terry

    Terry Administrator Staff Member

    Messages:
    14,889
    Location:
    Bothell, Washington
    That works with the 2" veritcal pipe on the vent.
  4. burnttoast77

    burnttoast77 New Member

    Messages:
    4
    Location:
    Savannah, GA
    Wow, from Terry himself! Thanks a bunch - I tried to get as much as I could out of the codes, but I just wanted to make sure.

    Thanks again.
Similar Threads: Toilet rough
Forum Title Date
Toilet Forum discussions TOTO Soiree lowest flow toilet really works and unifit for 14" rough in is great Jun 28, 2014
Toilet Forum discussions Hi Guys, Toilet Newbie. 14 Inch Width and 12 Inch Rough Jun 2, 2014
Toilet Forum discussions 10 inch rough toilet won't fit. May 9, 2014
Toilet Forum discussions Small Flushometer toilet 14" rough? May 7, 2014
Toilet Forum discussions Toto 10" Rough-in Toilet vs 12" with unifit May 6, 2014

Share This Page