Shower valve rough in

[Just1]

Good morning. I just finished having cement board installed in my tub shower combo. I noticed the Kohler shower valve is twisted to the left about an 1/8". Is this an acceptable tolerance or do these valves have to be dead on for the trim plate to look good? Thanks in advance.

 

[Just1]

I did a mock up with the cement board and it doesn't look bad at all.

 

[Sponsor]

 

[Terry]

Sounds good to me.

 

[Just1]

Looks decent right?

 

[Dj2]

It looks good and BTW, did you allow for tile (or other) finish?

 

[Just1]

It looks good and BTW, did you allow for tile (or other) finish?

Yes I did. That was just a mock up to see how it looked.

 

[hj]

It depends on how you measured the 1/8". It could either be a little bit or a lot.

 

[Just1]

It depends on how you measured the 1/8". It could either be a little bit or a lot.

Well the left center of the plaster guard measures 1/4" to the cement board and the right center of the plaster guard measures 3/8 to the cement board.