Pensacola Tom
New Member
I have a Rain Bird ESP-6TM controller for my sprinkler system. Program A and all settings works fine. Program B has not been used for past two years. I repaired the water lines and set up a drip system for bushes and flower pots. Over the past two weeks I have done test runs of Program B to check my repairs and it worked every time. My repairs are done so I programmed B start/stop, days and watering time, and it stopped working. When I try to manually start Program B, it does not run but Zone 1 of Program A runs?!?
Did I screw up the programming or does this sound like a stuck control value?
Did I screw up the programming or does this sound like a stuck control value?