Question...

Discussion in 'Plumbing Forum, Professional & DIY Advice' started by OldPete, Feb 9, 2007.

  1. OldPete

    OldPete DIY Senior Member

    Joined:
    Jan 4, 2006
    Location:
    NJ
    Found this question on another forum -- thought I'd ask it here:

    ---

    Ok, here's my plumbing question:

    I've got this noise coming from my basement. It's a vibration that comes and goes throughout the day. WAIT - don't say "water hammer" yet, read the rest of the problem!

    It seems to be coming from the general area where my supply line enters the house. All of these pipes are connected to the floor joists for the main floor so the vibration resonates through the floor and can be easily heard in my dining room above.

    We've been in this house since 1992 and never noticed this problem until we had some plumbing work done (by pros, not me!). 1) We replaced the plastic pipe from the street with copper and 2) We had a new water heater installed.

    I can't really isolate the exact source of the problem. It seems to be coming through the supply line from outside the house but I'm not certain. Sometimes it seems like it's coming from the pressure reduction valve that's in the same area.

    There seems to be no correlation between the noise and any use or non-use of water within the house. In other words the noise does not start immediately after a toilet is flushed or a faucet is opened or closed.

    The sound is a vibration that lasts up to 30 seconds or so. It's not violent or excessively loud but if you're in my dining room you can certainly hear it.

    Ideas?
     
  2. Rancher

    Rancher Guest

    PRV's will sometimes hum, or buzz, try touching it...

    Rancher
     
  3. Sponsor

    Sponsor Paid Advertisement

     
  4. jadnashua

    jadnashua Retired Defense Industry Engineer xxx

    Joined:
    Sep 2, 2004
    Occupation:
    Retired Systems engineer for defense industry.
    Location:
    New England
    Did they replace the water meter when they replaced the pipe? It may have a check valve in it that wasn't there before. You may also need an expansion tank.
     
  5. hj

    hj Moderator & Master Plumber Staff Member

    Joined:
    Aug 31, 2004
    Occupation:
    Plumber
    Location:
    Cave Creek, Arizona
    Prv

    A failing PRV can cause a vibration, either because it does not open fully, or has a problem trying to close when the flow stops. You could have something leaking, such as a toilet, that makes the flow start periodically.
     
  6. Master Plumber Mark

    Master Plumber Mark Master Plumber

    Joined:
    Feb 6, 2005
    Occupation:
    Sensitivity trainer...to be caring and loving to a
    Location:
    indianapolis indiana - land of the free, home of
    prv valve

    just make an adjustment to the PRV valve if you have one

    either turn it down or up and see if
    that does not make the buzz go away
     
Similar Threads: Question
Forum Title Date
Plumbing Forum, Professional & DIY Advice Natural Gas Fire Table hookup problem/question Today at 3:19 PM
Plumbing Forum, Professional & DIY Advice 2nd plumbing question Saturday at 5:54 AM
Plumbing Forum, Professional & DIY Advice basement bathroom, vent question? Thursday at 4:32 AM
Plumbing Forum, Professional & DIY Advice Looking to get some questions answered Aug 26, 2015
Plumbing Forum, Professional & DIY Advice Quick toilet drain slope question Aug 24, 2015

Share This Page