Need to Drill Small Hole In Cast Iron Receiver to Install Door

Discussion in 'Shower & Bathtub Forum & Blog' started by engnenk, Mar 17, 2009.

  1. engnenk

    engnenk New Member

    Joined:
    Jan 26, 2009
    I am installing Kinetik shower door in my new shower and I need to mount the guide onto the base. This means I need to drill two screw holes into the cast iron. Is this going to be a disaster? Will the drill chip and crack the porcelain? Is there an epoxy that will sufficiently bond to the porcelain?

    Suggestions?
     
Similar Threads: Need Drill
Forum Title Date
Shower & Bathtub Forum & Blog Need to Fill and Redrill Frameless Shower Door Mounting Holes Nov 4, 2011
Shower & Bathtub Forum & Blog Bath/Shower Valve question, need help Friday at 12:08 PM
Shower & Bathtub Forum & Blog intermittent drips, but need help identifying Tuesday at 6:55 PM
Shower & Bathtub Forum & Blog Need Advice: How to Close out top of Tub surround Jan 25, 2016
Shower & Bathtub Forum & Blog Kohler Niedecken, Need information on very old shower mixing valve Dec 8, 2015

Share This Page