Moen Shower Install

Discussion in 'Shower & Bathtub Forum & Blog' started by AdamD, Aug 11, 2014.

  1. AdamD

    AdamD New Member

    Aug 10, 2014
    I installed this weekend a Moen 1 handle Shower faucet and the water will not turn off - everything seems to be installed properly. Think I have a defective cartridge?
  2. Terry

    Terry Administrator Staff Member

    Aug 17, 2004
    Bothell, Washington
    It could be a cartridge problem. If the rubber panel on the side of the cartridge drops off before installing, that can happen. Or, you could have overheated the brass body while soldering. I remove the cartridge before soldering.


    The black rubber needs to be in place.
    Last edited: Aug 11, 2014
  3. Sponsor

    Sponsor Paid Advertisement

  4. AdamD

    AdamD New Member

    Aug 10, 2014
    I did not solder anything - it was a replacement and that was not necessary.
Similar Threads: Moen Shower
Forum Title Date
Shower & Bathtub Forum & Blog Shower remodel layout. Two Moen Positemp Valves Jun 5, 2016
Shower & Bathtub Forum & Blog What is this part and why can't I remove it? (Moen shower 1225) Mar 31, 2016
Shower & Bathtub Forum & Blog Moen Posi-Temp Banbury Model One Handle Tub/Shower Faucet - New install, hard to turn Feb 1, 2016
Shower & Bathtub Forum & Blog Moen single handle shower is slow to fully start and slow to stop Dec 28, 2015
Shower & Bathtub Forum & Blog old moen shower valve question Aug 13, 2015

Share This Page