Loose threaded joint

Users who are viewing this thread

Wally Pfautz

New Member
Messages
34
Reaction score
0
Points
0
I am installing a hand shower wall fitting onto a brass nipple. The fit between the threads seems sorta loose and I'm concerned that just using pipe dope or teflon tape wont seal between the threads. I wont know right away because any leak will be behind the wall. Is there a trick to ensuring a seal between loose threads?

Thanks,
Hazel
 

Markts30

Commercial Plumber
Messages
625
Reaction score
1
Points
0
Location
Phoenix, AZ
If the joint will not make up tight with the length nipple you have, remove it and use one 1/2" longer....
Tef tape and dope are not for making loose joints tight...
 

Wally Pfautz

New Member
Messages
34
Reaction score
0
Points
0
It does "bottom out" on the threads

I just don't trust that even bottomed out and tight that water wouldn't leak past if the threads were so loose
 

GrumpyPlumber

Licensed Grump
Messages
1,521
Reaction score
57
Points
48
Location
Licensed Grump
If there's any play in the fitting once you've hand tightened it then something isn't right.
You'll want to read the MFG info and be sure the threads are "1/2" IPS" or "1/2" NPT" threads.
If you're unsure...use both dope and Teflon...put the tape on in the same direction the fitting spins tight so the tape doesn't roll off as you tighten it.
 

Wally Pfautz

New Member
Messages
34
Reaction score
0
Points
0
Thanks (and an aside)

I saw an episode of "Ask this old house" where the plumber used what looked like string in the threads and pipe dope to connect an old radiator which had a sloppy fit
 

Jadnashua

Retired Defense Industry Engineer xxx
Messages
32,770
Reaction score
1,190
Points
113
Location
New England
There are tapered threads and straight threads. If the threads on the fittings you have are BOTH tapered threads, it will get tighter as you screw it in and unless one is defective, you should not be able to bottom it out in the fitting. But, if one or the other is a straight thread, it will never seal with pipe dope and teflon (at least not reliably). That type of fitting, like a hose, needs a gasket to allow it to seal.
 

Leejosepho

DIY scratch-pad engineer
Messages
2,483
Reaction score
0
Points
36
Location
200 miles south of Little Rock
Website
www.nonameyet.org
I just don't trust that even bottomed out and tight that water wouldn't leak past if the threads were so loose

Like one of the scenarios Jim mentioned, my guess is that the end of the hand-held has straight threads and an integral washer or seal of some kind. If that is the case, it should "bottom out" and there is no need for tape or pipe dope or for being concerned about the threads seeming to be loose in comparison to having tapered threads on both pieces unless the end of the nipple is badly formed or deformed.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks