Kitchen Sink Rough in

Discussion in 'Plumbing Forum, Professional & DIY Advice' started by rockycmt, Feb 25, 2009.

  1. rockycmt

    rockycmt Member

    Joined:
    Nov 13, 2007
    Location:
    New York Metro Area
    Supply lines.

    1/2 inch coming up from basement. The original had solder 90 degs to a 1/2 1/4 turn valve. I have seen in the past some rough ins 1/2 in copper soldered to a 90 deg female. And a nipple is used to the 1/4 turn valve. Which is a better approach? and Why?
     
Similar Threads: Kitchen Sink
Forum Title Date
Plumbing Forum, Professional & DIY Advice Kitchen Sink drain needs to lower; could I swap drain with stand tube? May 13, 2016
Plumbing Forum, Professional & DIY Advice Will this kitchen sink drain fitting fit? May 8, 2016
Plumbing Forum, Professional & DIY Advice What Is This Pipe Under My Kitchen Sink, And Can I Get Rid Of It? May 5, 2016
Plumbing Forum, Professional & DIY Advice When should I replace my disposer on my kitchen sink? Apr 23, 2016
Plumbing Forum, Professional & DIY Advice Standard Spacing Between Kitchen Faucet and Sink Apr 13, 2016

Share This Page