petepdx
Member
Looking at options for adding water hammer arrestors to a Uponor (ProPex) setup. Suggestions on going from the brass MNPT of the arrestor to the pipes.
So far only thing I can come up with is a Pex - Pex - Pex tee then a short nipple of pex pipe then a pex - female NPT.
Have not found a Pex - Pex - NPT tee
I feel I'm missing something less complicated ..
Suggestions ?
-pete
So far only thing I can come up with is a Pex - Pex - Pex tee then a short nipple of pex pipe then a pex - female NPT.
Have not found a Pex - Pex - NPT tee
I feel I'm missing something less complicated ..
Suggestions ?
-pete