Gap in Seat of Toto S300 Washlet

Discussion in 'Toilet Forum discussions' started by ash4889, Mar 25, 2011.

  1. ash4889

    ash4889 New Member

    Messages:
    4
    Location:
    South Florida
    I finally got a washlet S300 made by Toto its great the only concern is that I noticed the seam between the two halves of the main toilet seat are not completely sealed at places I wonder if water splashing on it can eventually get inside the seat and cause problems. I called Toto and a rep answered and said its normal to have a gap like that on the seat, I find that hard to believe on a Toilet seat that lists for $1400 that a gap like that is normal.

    Attached Files:

    Last edited by a moderator: Mar 26, 2011
  2. ash4889

    ash4889 New Member

    Messages:
    4
    Location:
    South Florida
    plus when I lift top of seat when its up like that, the whole thing lifts up from base at least a half inch.
  3. Terry

    Terry Administrator Staff Member

    Messages:
    15,416
    Location:
    Bothell, Washington
    If it lifts up, then it's not tightened down. The mounting plate is installed with supplied toggles, and then the seat slides into and snaps in.
  4. ash4889

    ash4889 New Member

    Messages:
    4
    Location:
    South Florida
    This is a picture of it when I lift the front of seat[​IMG]
  5. ash4889

    ash4889 New Member

    Messages:
    4
    Location:
    South Florida
    Here is a picture of mounting plate [​IMG]
Similar Threads: Seat Toto
Forum Title Date
Toilet Forum discussions Troubleshooting lack of seat heat in Toto s300 Washlet? Dec 8, 2014
Toilet Forum discussions Toto S350e Bidet seat review. Nov 8, 2014
Toilet Forum discussions Remove stubborn Toto toilet seat Oct 12, 2014
Toilet Forum discussions soft close seat for Toto Pacifica Mar 28, 2014
Toilet Forum discussions INAX toilets? TOTO Supreme? Coway bidet seat? Nov 24, 2013

Share This Page