Fleck 90deg adapter?

Discussion in 'Water Softener Forum, Questions and Answers' started by 70runner, Sep 28, 2013.

  1. 70runner

    70runner New Member

    Joined:
    May 25, 2012
    Location:
    Fallbrook, CA
    My 9100SXT twin tank install needs to be close to the wall. I found a 3/4" adapter for the 9100 here, unfortunately my supply line is 1". Would this work or does Fleck have a 1" 90 adapter?
     
  2. mialynette2003

    mialynette2003 Member

    Joined:
    Nov 24, 2010
    Occupation:
    Owner of SWS Systems WWW.SWSSYSTEM.COM
    Location:
    Ocala, Florida
  3. Sponsor

    Sponsor Paid Advertisement

     
  4. 70runner

    70runner New Member

    Joined:
    May 25, 2012
    Location:
    Fallbrook, CA
    Not sure how those would solve my prob. Looking for a 90 elbow yoke assembly, a 1" version of this:

    90adapter.jpg
     
  5. mialynette2003

    mialynette2003 Member

    Joined:
    Nov 24, 2010
    Occupation:
    Owner of SWS Systems WWW.SWSSYSTEM.COM
    Location:
    Ocala, Florida
    I mis-understood. Thought you where looking for 1" adaptors to connect piping to the 90 deg yoke.
     
  6. 70runner

    70runner New Member

    Joined:
    May 25, 2012
    Location:
    Fallbrook, CA
    No problem. I was basing my question on the valve I'm familiar with, the Fleck twinflo, where it opens to the rear. I assumed the 9100 did also, but apparently it opens to the side which solves my wall proximity issue.
     
Similar Threads: Fleck 90deg
Forum Title Date
Water Softener Forum, Questions and Answers Fleck 5600sxt master settings Yesterday at 11:18 AM
Water Softener Forum, Questions and Answers Lots of resin discharged during regeneration, Fleck 5600sxt Sep 23, 2016
Water Softener Forum, Questions and Answers Have quotes for Fleck 7000sxt and Autotrol 268-760 Sep 22, 2016
Water Softener Forum, Questions and Answers Fleck5600SXT 40000 grains capacity water not tasting good after salt clog Sep 13, 2016
Water Softener Forum, Questions and Answers Fleck 7000, Valve body failed Aug 31, 2016

Share This Page