Did my Plumber glue this correctly?

Discussion in 'Toilet Forum discussions' started by Mike2187, Mar 12, 2011.

  1. Mike2187

    Mike2187 New Member

    Messages:
    10
    Location:
    Maryland
    My plumber installed a no hub coupling To a copper 3 inch pipe to replace a cast iron toilet flange. I needed the flange to be closer to the floor because I am putting in new tile and ripped up the old layers of subfloor. To get the flange lower he installed a 45 degree toilet flange (sits closer to the floor). Here is a pic of the assembly:
    [​IMG]

    I spotted what looked looked like no primer anywhere:
    [​IMG]

    Inside
    [​IMG]

    1. Did he use PVC glue without primer?
    2. Is it acceptable with certain types of glue?
    3. Are there any problems with a 45 degree closet flange?
  2. cacher_chick

    cacher_chick Test, Don't Guess!

    Messages:
    3,281
    Location:
    Land of Cheese
    There is clear primer, so it is hard to say about the "glue". The 45 flange looks fine.
Similar Threads: Plumber glue
Forum Title Date
Toilet Forum discussions Rant - Licensed plumber doesn't mean squat Jul 13, 2014
Toilet Forum discussions Plumber installed double sanitary tee in back to back install of eco drakes Apr 12, 2014
Toilet Forum discussions Plumber used Non Standard Water Supply Location & Toto Toilets Jan 6, 2014
Toilet Forum discussions Bad plumber or what?? Jun 27, 2013
Toilet Forum discussions Toilets with bidet features, Ed the Plumber, Ed Del Grande Apr 2, 2013

Share This Page