Hello everyone,
This is just a quick question. The drain line below my bathroom sink is further down the wall than the standard Home Depot DIY P-trap "kit" allows.
In order to accommodate the fact that the P-trap at the sink side did not come up far enough to meet the drain tail from the sink, I added two 90° street elbows to raise the height of the wall outlet. This has effectively now created an S-trap.
Will this cause any issues? I'm in N. California.
Image:
http://imgur.com/5VoW0cB
This is just a quick question. The drain line below my bathroom sink is further down the wall than the standard Home Depot DIY P-trap "kit" allows.
In order to accommodate the fact that the P-trap at the sink side did not come up far enough to meet the drain tail from the sink, I added two 90° street elbows to raise the height of the wall outlet. This has effectively now created an S-trap.
Will this cause any issues? I'm in N. California.
Image:
http://imgur.com/5VoW0cB
Last edited by a moderator: