clack ws1 C1 no power

Discussion in 'Water Softener Forum, Questions and Answers' started by tedward74, Nov 14, 2011.

  1. tedward74

    tedward74 New Member

    Joined:
    Nov 14, 2011
    Location:
    ireland
    ok first time post and I have read a good lot of the threads.
    I have this installed about 19 months. all was working fine until i looked at it yesterday and there is now power on the screen. water has obviously not been softening for about a week as the salt level hasnt moved. I check under the sink at the 12v power supply is plugged in and hot.
    there is a break connection that has been twisted together with electrical tape about a foot from the 12v plug ie 2 cables had been joined badly by the installer because he realised the wire was too short and needed to extend it.
    could it be the problem is there ie the cables have shorted or is it amore serious problem.
     
  2. Tom Sawyer

    Tom Sawyer In the Trades

    Joined:
    Nov 29, 2010
    Location:
    Maine
    I would certainly start there.
     
  3. Sponsor

    Sponsor Paid Advertisement

     
  4. tedward74

    tedward74 New Member

    Joined:
    Nov 14, 2011
    Location:
    ireland
    ok apologies for the late update on this issue but it took months to sort with the original vendor of the system. eventually they stated the circuit board was blown and they replaced it with a new board that did the trick at no extra cost to me after a lot of haggling back and forth.
     
Similar Threads: clack power
Forum Title Date
Water Softener Forum, Questions and Answers Clack WS1 - two tank GAC setup ? Sep 11, 2016
Water Softener Forum, Questions and Answers Clack WS1 backwash ? Sep 10, 2016
Water Softener Forum, Questions and Answers Clack V3006 - manual backwash Sep 1, 2016
Water Softener Forum, Questions and Answers Clack bypass valve, reliability ? Aug 18, 2016
Water Softener Forum, Questions and Answers Aqua Pure CBF100 carbon filter Clack drain line leak Feb 18, 2016

Share This Page