Boiler/Water heater question

Discussion in 'HVAC Heating & Cooling' started by tonkin1983, Nov 7, 2007.

  1. tonkin1983

    tonkin1983 New Member

    Messages:
    3
    I recently bought a house which has an oil furnace and a new electric hot watewr heater. The furnace has been on for about a week and there is a pipe which is connected from the output of the boiler to the cold-side input of the water heater. The connection on the cold water input side of the water heater has developed a drip since the furnace has been on
    I am wondering why it is dripping? Too much pressure? The connection is new. Any ideas?
Similar Threads: Boiler/Water heater
Forum Title Date
HVAC Heating & Cooling Water heater vent Nov 18, 2014
HVAC Heating & Cooling Old propane space heater not starting up fully after pilot is on Nov 2, 2014
HVAC Heating & Cooling Toe Kick Under Kitchen Counter Electric Heater Nov 1, 2014
HVAC Heating & Cooling Can I change to regular hot water baseboard heaters? Aug 5, 2014
HVAC Heating & Cooling Electrical question fir 5 ton pool heater heat pump Feb 28, 2014

Share This Page