gas fitting

  1. Roland

    Tightening a gas union..

    Hello All, If a gas union has a slight leak, is it acceptable to attempt to check tightness/tighten union ring with the gas still on? I.e. Spark concerns, etc? I assume this is an obvious NO DO NOT, don't be a fool!, but was wondering if it turns out this is not a problem. Thanks!
  2. SBpropertiesGA

    Replacing gas range question

    As part of a remodel I am replacing an older gas range. The new range has a larger diameter flex pipe and fitting than the old one and will not screw into the valve. Can I use an adapter to make it fit the old valve? Will the range still operate properly if I do? Or should I replace the...
  3. Drew Toddsby

    Properly tighten black steel gas piping

    Hey guys! Longtime lurker, first time poster. I'm in the process of teeing off a gas line for a new gas dryer in our second story mudroom / laundry room. We currently have a gas furnace in the attic and gas water heater in the garage. I bear crawled through the attic to trace the gas line from...
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks