Search results

  1. Kookieman69

    ferrous iron in pipes

    gentlemen , I replaceing old electric water heater the supply lines that are brown from ferrous iron ,I have installed a water filtration system and need to know what I can do to flush out supply lines, i have thoght about putting something in tank before hooking up cold water supply line...
  2. Kookieman69

    iron in water

    i have 2.5 cu ft acid nutralizer tank fleck sxt control water clean after regeneration cycle when it sits in toilets it turns very brown ,i suspect its desolved iron , my wife and i are both 75 house has 3 bathrooms no kids house will probly be a gut or tear down when were gone , we would just...
  3. Kookieman69

    Pressure switch ( follow up )

    I installed a 2.3 cu ft acid neutralizer and started having trouble with low pressure switch ( 30/50 ) cutting off I thought I might be drawing enough extra water to kick the switch, so I replaced it with one that doesn't have low pressure cut off . I then turned on back wash and watched gauge...
  4. Kookieman69

    Pressure switch cutting pump off

    Hello, I just installed a new pressure tank and 30/50 switch for my deep well with submersible pump. I also installed a 2.5 cu ft acid neutralizer, when the acid neutralizer back flushes the pump loses pressure and cuts off. It works fine when not back flushing. Any ideas what could cause...
  5. Kookieman69

    Installing tee on pressure tank

    hello, when installing Tee at bottom of tank holes for switch and gauge aren't on the top, it still won't make another complete turn. anyone know any tricks to get it tight and have holes on top thanks, mike
  6. Kookieman69

    Pressure tank

    Hello, do pressure tanks hold a reserve of water . I was in my crawl space changing filter.i happened to Rock my tank and it seemed very light ( empty) I thought it held a certain amount of water . It is a deep well drilled 220 ft and I am getting muddy water .i thought it had built up in tank...
Top