Search results

Anyone have any recommendations on a high quality magnetic contactor for 1 hp Berkley submersible pump. It will be running at 240 vac ~10 amp, but will want the coil to be 120 vac. Thanks in advance

I'm trying to determine if I just got someone there that is either too busy, incompetent, or whether the company is just not trustworthy. Should I stay away from them, or try to connect with someone else. Thoughts, experiences?

We want to filter iron, manganese from a new well, prior to it entering a couple of 5,000 gallon storage tanks. . Our Iron levels are .740 mg/l and Manganese .051 ppm. There is also a slight sulfur smell (hydrogen sulfide), but figure the filter will be able to deal with that as well. Water...

We want to filter iron, manganese from a new well, prior to it entering a couple of 5,000 gallon storage tanks. . Our Iron levels are .740 mg/l and Manganese .051 ppm. There is also a slight sulfur smell (hydrogen sulfide), but figure the filter will be able to deal with that as well. We're...

I am trying to replace the hose on faucet, and it won't disconnect. I have removed the plastic clip that locks it onto the copper line, but pulling down on the fitting doesn't have much affect. There is a difference in the connector when comparing the replacement hose and the old hose. The...

I have a well with a 3/4 HP submersible, and the difference in current when under load and the "run dry" case is too small to allow a good set point to trip the controller. If I ever have to replace the pump, I'll size it correctly so the contrast between normal load and run dry is more...

We've been using our well for ~20 years, but haven't had the need to do much since installing - so, somewhat of a newbie... I'm looking for feedback on any errors in my thinking (shown below), or if there are any downsides? Are there better solutions? Also, checking whether...