Search results

I am remodeling a bathroom and I finished laying the porcelain tile floor and left the rough-in for the toilet exactly where the old one was. The toilet riser underneath was 4" copper and I explained that to them in advance and they ordered the right size flex coupling to connect the PVC from...

Hello, I am remodeling a bathroom and I need to cut out an old 4" copper pipe in the crawlspace that is run very tightly between two joists. I can't get my reciprocating saw on it and I don't think I can get a regular hacksaw on it either. Any advice on how to cut this pipe? Also, when...

I have two main question: I need to run conduit into a weatherproof j box with no holes. Which adapters do you use for the j boxes with no holes? After you drill the hole do you use the the adapters with screw on rings...

I am moving an oven and need to splice about 15' of 10/3 onto the existing cable. The existing cable is 10/3 with no ground and the new cable I picked up is 10/3 with ground. What should I do with the ground when I make the splice to extend the cable, should I leave it unconnected or should I...

So I am working on a remodel and I disconnected a light fixture and I found three cables into a junction box where a neutral was connected to two of the hot wires. The hot and neutral pigtails you see in the picture were being used to power the light. Why wouldn't all of the hot and neutral...

I am remodeling a bathroom and planning to tile the floor. I laid the first layer of underlayment and now and I realize I made a mistake by cutting out the hole for the toilet flange too large. I cut it to fit over the flange so the flange won't be sitting on top of the underlayment. So that...