Search results

Going on the suggestion from Reach. Thanks Reach. I tested the power supply on DC, I thought it was dead.. then realized it was AC and it tested normal. Figured the electronics must've blown from the last snow storm power failures. I removed the circuit board to verify the P/N. examining...

there is power going into the power head since the display does light up. although, you have a good point, maybe the wall wart is not working at it's normal output. i'll test it out later. I'll look into those part #s as well. thanks

Hi All - I have a Fleck 5600sxt 48K grain water softener that was installed 10 years ago. The display on the power head is blank. I tried to reset it a few times with the "hold cycle button and plug it in method", but no changes. Question - Does anyone know if I can I just replace the power...

I was looking for a bit, but never found the right parts... thanks I installed the 5600sxt last week using the flex pipe and the Fleck by-pass valve. No major issues report besides having to use some teflon to stop the connections from leaking. Thanks for the help.

Thanks your help.. I'll be ordering the system this week.

Here's some pictures. The pipes are accessible to re-plumb if needed. Thanks for the suggestions.

Hi - I've been lurking trying to find an answer but haven't seen one.. So decide to register and ask.. I have 15+ year old Culliigan N8 Custom, it's been working fine up until 6 weeks ago. The motor/valve was stuck in the open position causing it to continually discharges. After...