Search results

  1. Spaceball1

    Cracked PVC Toilet Flange

    I'm replacing a toilet in an upstairs bathroom. Subfloor is plywood, finished floor is linoleum made to look like hardwood. House was built in '96 so this After removing the old toilet & removing the old wax ring, i noticed that the flange was cracked. Since the old toilet didn't have any...
  2. Spaceball1

    Sink drain from wall is 2" ABS. What to do?

    I'm putting in a sink for us to use temporarily in the kitchen while I build our cabinets and wait on granite. I bought a cheap laundry sink that has a 1-1/2" threaded drain. I also bought 1-1/2" slip joint P-trap kit. (Not my favorite, but that's what's usually installed, right?) However, the...
  3. Spaceball1

    Gas line - Converting from dryer to range

    Next up on my remodel.. Our townhome was set up for an electric range and gas dryer. I'm swapping the two. The main gas supply comes in on a 1/2" line to the utility room where the regulator is. The regulator feeds an iron pipe manifold. From that manifold, there are 1/2" soft copper lines to...
  4. Spaceball1

    Icemaker/fridge supply box depth...

    Sometimes I swear that Big Orange (Home Depot) exists just to make my life miserable.. I'm installing 1/2" copper from a supply line in my lower level utility room to the wall behind my fridge (in the upper level kitchen) I bought their standard icemaker box/valve, drilled a hole in the middle...
  5. Spaceball1

    Ok to put slight bend in 1/2" hard copper pipe?

    I'm installing a new 1/2" hard copper (blue) line from my utility room to supply water to my fridge. Since I'm new at soldering copper, I wanted to figure out a route that would minimize soldered joints inside walls & ceilings. I found a solution that puts a single 45 degree soldered joint that...
  6. Spaceball1

    Moving kitchen sink, want to get it right..

    We're remodeling the kitchen in our townhome and have removed all of our cabinets. We're working on the design for the new cabinets, and I came across a couple of questions. The old sink was in the middle of a wall, so that's where my drain & supply lines are at. We're hoping to move the sink...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks