Search results

The flush handle sticks open when the toilet is flushed and continues to fill the tank until the handle is physically pulled up. I replaced the flapper and that solved the problem temporarily. I don’t recall if thr replacement flapper is the one regularly recommended here or a Toto. I got it...

Finishing up a kitchen remodel. An Insinkerator Badger 500 was installed. Less than 2 weeks in use. When it is turned on it sounds like a bunch of steel is clanking around inside. I looked inside and see nothing that could be causing the sound. The chamber is completely empty. The two...

She flushed a small rag down the upstairs toilet with my guests coming over soon. The toilet will flush but the tub directly below is backing up if I run the shower upstairs the water backs up into the downstairs tub? Short of calling a plumber any DIY suggestions? can I drano the rag?

I have a Toto Ultramax (MS853113S) round bowl. I determined the tank is not filling all the way to the fill line on the overflow tube. The water line when the tank stops filling is about 2 inches below the fill line. The consequence is that the toilet is clogging frequently, especially when...

I am installing a new sink and vanity in a bathroom. The house was built in 1965 and the original sink is being replaced. The drain pipe sticking out of the wall is corroded to the point the pipe is disintegrating and the threaded end of the pipe is breaking off. See photos. I tried to...

Recently remodeled my bathroom. A new Kohler Rite Temp K-304 valve was installed. After the shower was tiled we discovered that the valve was installed too far forward so the escuctheon that fits over the valve will not fit flush against the wall, which is what the instructions call for...

I have a 7 yr old Toto Ultramax (model 854??). Water keeps filling into the overfill tube after flushing. If I apply pressure to the side closest to the flush handle it will stop. Should I start with a cap replacement or take it apart and clean it? Also, I started messing with it before...

I have a Toto Ultramax toilet that appears to need a flapper replacement. The eyelet on top of the flapper that attaches the chain to the flapper ripped. Toilet is about 4 years old. Should I go with the standard Toto replacement part or is there an aftermarket part that is a better option.