Search results

  1. Fastgt79

    Over drilled (>60%) thru non-load bearing stud and need options to meet code

    I drilled a hole in a non-load bearing stud greater then 60% for a drain pipe. Are there metal braces that can be attached to the stud to add support and meet code? What are my options other then replacing the studs and re-routing plumbing (there is no other route for plumbing)?
  2. Fastgt79

    New basement bathtub question

    I am installing a bathtub in my basement that has rough-in plumbing. The rough-in bathtub floor drain stub out is about 1" under water in the drain box. What are my option for connecting the drain trap to a stub out that's a little under water?
  3. Fastgt79

    Question on drain for utility sink install in basement

    I am installing a utility sink in my basement right next to my sewage ejector pit. My plan was to install a drain trap underneath the utility sink drain then use a PVC wye fitting to connect to the ejector vent so that everything from the utility sink drains in the ejector pit and that I do not...
  4. Fastgt79

    Which brand for RPZ, Watts or Cash Acme?

    I am installing a water powered backup sump pump and code requires a 3/4" reduce pressure zone (RPZ) valve on the water supply to the sump pump. The two brands that seem pretty popular on the internet for RPZ are Watts (model 009M3QT) and Cash Acme (cash-flo RPZ II). What brand has a better...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks