Search results

So the heat pump would be to heat the air? I am looking to heat the slab but sounds like I might be better off with a real boiler and a slab sensor. Thanks for the input.

I am currently heating my attached garage with a 4KW electric workshop heater. I have tubing in the floor for radiant heat and I want to take advantage of radiant floor heat. Please note electricity is my only energy option. I am thinking of installing a 6KW high-flow tankless WH as my...

If the top of the flange is level with the finished floor will a standard size wax ring be good enough or should a thicker one be used? Is it possible that the thicker one will have too much wax and cause problems or can you not really have too much wax.

I did the bucket fill test after turning off the pump, draining down the tank, leaving the drain valve open with the hose end in the pail. At that point I flipped on the breaker and started my stopwatch. And as I said, it filled the pail in about 20 seconds. So you don't think that if a faucet...

I tested the gpm of the pump by filling a 5 gallon pail. I could fill the pail in about 20 seconds, so there seems to be no shortage of flow from the pump. I think it must be that since I am opening the tank tee drain valve that basically water is flowing straight from the well out the valve...

I have connected my pressure system at my new house. We are using our existing submersible pump and well from our previous mobile home but are using a new pressure tank. The system will kick on at 30psi an kick off at 50psi as expected and hold 50 psi while the faucet is not opened. The problem...

I am running the supply lines in my new house and cannot decide which way to to run my lines. I am thinking about doing it one of the following ways. a) Use a manifold system that would run a 1/2" line to each room that requires plumbing except for bathrooms would get a 3/4 line instead. From...