Search results

  1. Oldyota

    Opinions needed??? PEX or Copper??

    I'm remodeling my basement bath and need to move some supply lines.. I'm pretty good at sweating copper, but looking at the PEX for the new connections. Which do you guys prefer or think is the better choice... It will be installed in a 2x6 wall if that helps.
  2. Oldyota

    Basement bathroom renovation???

    I understand the no hub route....... This pic shows the stack layout, I've tried to label them in paint I hope it helps.... Redwood the pvc from the cast iron goes to the shower trap. Can I use the existing vent? As you see in the pics there is a vent for the washer, toilet, and lav the pipe...
  3. Oldyota

    Basement bathroom renovation???

    How would you recommend to cut it?? The main drain was put in 1966, I was also wondering how you get the new fittings to seal up on all the corrosion.. Been looking at the hub couplings is that what you talking about?? Rubber gaskets with the stainless clamps??
  4. Oldyota

    Basement bathroom renovation???

    First off want to say hello to everyone on the board, been searching and reading alot of posts educating myself.... I'm currently in the process of renovating my basement bathroom , it had a shower stall, toilet, and sink already installed but very bad placement... So I've removed everything...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks