Search results

Good Afternoon, I have a new vanity and faucet I am installing.....and am using solid 3/8 supply risers. The faucet connection and stop valve are about 5 inches apart with a approx 2 inch offset so I cannot get an adequate bend on the supply rider tube. I wish I installed the stop valves facing...

Good evening. Located in new York, Been looking for an applicable post but I don't see any that apply. I need to tie in the 3 inch PVC seen n the picture into a cast iron horizontal run. I know that I need to add supports to the cast before I cut for all the extra weight, but my question is...

I was wondering if someone can help. I have searched the forums and web but can't find info. Most everyone says to use flexible braided lines from shutoff to faucet but I prefer the solid riser lines. Anyway, I understand how to connect solid riser at the shutoff with the compression nut and...

I posted this in general but figured I probably should have placed it in code questions....I am looking to see if the bathroom in my basement follows code. I attached a diagram (crude) i am in Town of Brookhaven on LI New York. Mostly can venting system and ejector share same 2" vent to roof...

I am looking to see if the bathroom in my basement follows code. I attached a diagram (crude) i am in Town of Brookhaven on LI New York. Mostly can venting system and ejector share same 2" vent to roof? Thanks, Mike

I drew up a crude picture of what i am looking to do. What i need to know is if each toilet needs its own vent? how many 45 deg bends and wye in horizontal run? I would like to arrange the existing 3" branch for both toilets. If not I will have to do much demolition in the finished basement. I...