Search results

Rkulp89 did you get this resolved? My Fleck 5600sxt brine tank water level is also consistently over the salt level. Thanks.

Fairly certain it's ppm because there was some equation you have to do to figure it out. Plus the report for the softened waters says the total hardness is low.

Thanks Smooky. The softened water was 7.8 with total hardness at 4. The unsoftened was 7.6 with total hardness at 395.

Thanks Reach 4. Where does one get the Corrosivity ( Langelier or Ryznar ) test?

We moved into new construction 9/1. We have plastic tube PEX plumbing. Recently had the control on our Bradford White replaced and at that time our new plumber took a look at the rods in the tank with a camera. He was amazed they had a lot of scale (looks like calcium) on them already. I have...

New Diagrams OK, What I think you're saying is this... Any reason I couldn't Tee off right at the top before the water even travels down to the tank? Also, any idea how this might effect inside water pressure while the 4 or 5 outside spigots are running? Thanks for all your help...

Larger Pipes, Etc. OK, sorry I've lost track of all the different advice from the posts. I really wasn't ignoring them, the thread has just gotten so long. Below are two photos of what I think you're describing Bob NH. Please let me know if you see any red flags in my interpretation. Are you...

Good News / Bad News The good news is tightening the screw to adjust cut-in to 50 and cut-off to 70 and adding the extra 10psi to the tank via bicycle pump DEFINITELY increased my water pressure outside. The bad news, the pump is cutting on every 30-35 seconds now instead of once every...

So if my bladder runs 40-60 and when the tank is drained the pressure is 37 what should I increase/decrease the pressure to before bumping up the cutoff pressure to 70? Sorry to sound so stupid but there has been so many suggestions and I don't want to fry my system. By the way I'm pretty sure...

Upping pressure So you are all saying I should bump up the pressure in my tank from like 37 to 47 if I increase the cut off PSI from 60 to 70. Just making sure. Thanks.

OK, my screen name is DumbonPlumbing for a reason. How the heck do I adjust the pressure? Tighten one or both of these threads with the springs in the picture? Once I know how to bump it up to 70 I'll do it and follow further instructions about the faucets. Also, noticed earlier the...

My Faucet Heads

Quick update; Tank Pressure Finally got a chance to check the tank pressure tonight. Before draining: 53.0 After draining 37.0 So is that the general consensus, bigger faucet heads and bumping up the pressure switch? Thanks all. Pictures of faucet heads to follow.

Thanks? Head Spinning. OK. Lots of opposing opinions now. I think what I'm hearing is... 1. Replace the pipe lines to the spigots with a larger size. 2. Insert the CSV. (Not sure where. After or before the existing pressure switch?) Both of which I'll have to get a plumber to do. Could...

Thanks & Updated Pictures! Please know how much hope you have given my wife and I. We've been given so much run-around from these well companies. You're really helping us out. Here are new pictures. The pipe leading to the two exterior spigots is definitely smaller in diameter than the other...

Will Try I can tell you that the pipes leading to the outside spigots are smaller in diameter than the pipes that lead to inside fixtures. Would this cause less pressure? I will try to hook up a hose directly to the outside spigot. Right now it goes through the hose reel so I'll eliminate...

Speedbump? So are you saying: 1. My current pump is adequate for my 3/4 acre yard? 2. That outputting more water outside by Y connectors, multiple hoses, etc. will keep the pump from cutting off so much? 3. That my tank bladder is or is not shot? 4. What do I do about increasing the water...

Great ideas! Thanks. Just did the faucet tips. Both had a little debris but didn't smell. Bleached them anyway. Since bleaching the overflow sink holes I haven't smelled the smell in a few days. Will try the bleach in the water heater and softener if the tips doesn't do it. Will keep you...

Pump in the well. Myers Hydro-pneumatic pump tank 1/2 HP Inside water pressure fine. Outside always been poor, and we want to increase that. We have 3/4 acre with several lengths of hose and watering tractors, but even with one hose and a hand sprayer the pressure is low...

Hydrogen sulfide smell from two bathroom sinks only. Showers, kitchens, etc. fine. Degree of odor varies from none to barely noticeable to very noticeable. Odor will fade if faucet is left running for 20 seconds or so. Odor can arise whether faucet has been recently used or dormant. Most...