Search results

Pump was culprit Decided to haul up the pump when the weather got warmer and changed it for a new one. All wiring on old pump looked okay so must have been the motor that was letting go. Also noticed it was a 1/2 HP down at 190ft. Opted to replace with a 3/4 HP in hopes of prolonging the life...

I had this happen once. It turned out to be the float/switch for pump start stop. The pump was fine but I was unable to repair the switch so there is a kit you can buy which is basically a float switch that you have to install in the tub and attach it to the pump. You then plug this into the...

Re: Softener Correct there is an Iron master before the softener but even with that the treated result is still high in TDS. Re: Switch Yes, had a closer look and the points stay shut until cutoff is reached. Re: Water Flow / PRV It is before the switch and pressure tank. Is plastic &...

I tried some tests adjusting the flow control valve and still the same result. It is definitely the pump that is shutting down and nothing to do with the switch so now I am seeing dollar signs. Still freezing cold here in Ontario, Canada so I will have to wait and see what happens come spring...

I thought it might be a low water condition too but this behaviour is happening even if you let the system sit idle all day. The well at time of installation showed a pumping rate of 13.65 L/min or 3.61 gal/min so it is not great but have never had any issues for the last 10 years. The kicker...

Hello All. I am new to the forum and seek your input on problem I am having. Always lived in the rural area so I have a working knowledge of water well systems. First off, I will summarize what type of system I have. 200+ FT deep well with submersible pump, Flow control butterfly valve set to...