Search results

The specs on the Toto's with the adapters for a 10' rough in are still a little too long. The boss (wife) is making this difficult. I have found a Home Depot brand that is 10" with the proper length, but I am reluctant to install it. I'll look at the Mansfield.

I attempted to purchase a Toto Drake with a 10" rough-in, but they only have 12". Does anyone know of a quality brand that has 10"? I have to have a round bowl. I do not wish to use an adapter- the toilet will sit in a small 1/2 bath.:confused:

I further reduced the pressure to 60, and the whining is now very infrequent. Hopefully, a further reduction will not be needed. It all depends on what my wife decides.

I used stainless steel. I shut off the toilet valves one at a time, then both and still had the noise. It appears to be initiated by the faucets in the upstairs bath, the furthest from the intake lines. Using other faucets does not do this until the upstairs faucets (now BOTH hot and cold) are...

I did replace them at the same time.

I had 120 lbs of pressure due to a faulty PRV. I replaced it, and the reduced pressure (73lbs) did not allow the two upstairs toilet valves to open. They were replaced and now work fine. The cold water line whines when any cold water faucet is used, so I cannot isolate the problem to a specific...