Search results

  1. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    This is the main problem , I have no idea about the shipping cost plus the customs cost , so after I pay you $179 plus shipping to Egypt plus customs in Egypt I have no idea how much would be the total cost but am sure it would be very very expensive
  2. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    The main problem is that the CSV is NOT available in Egypt so I am asking if other components combination can give same effect of CSV
  3. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    Is it possible to build up a plumbing system using Pressure Regulating Valves , Pressure Tank , Non Return Valve, Bypass Valve and Pressure Switch in a way to give the same effect of the CSV Valve ?
  4. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    Unfortunately I can not buy such controller in Egypt , all controllers here shut the pump when flow is zero or at its max pressure the pump can produce Valveman , is it possible to buy your CSV on Amazon USA? Are you the inventor of that CSV kind of valve?
  5. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    d change in pressure causes immediately change in flow which by its turn cause change in water temperature in my system I NEED THE PUMP TO BE RUNNING CONTINUOUSLY DURING SHOWER .
  6. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    It is one independent house with its own water heater, no body uses water if somebody having shower so the only reason of the problem is cycling
  7. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    The main problem caused by cycling is the hot / cold water blasts during shower , that is why i prefer the pump to be continuously running to maintain the right water temperature during shower
  8. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    Actually the pump I have produce 5 bar on its own add to that the city pressure at night which can reach more than 1.5 bar so the total pressure can reach 7 bar which is too much for the piping system I know that the CSV is the best solution but I can not find it in Egypt , any suggestions to...
  9. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    As I said before , my problem with a pressure switch and a pressure tank is cycling during shower which results in hot and cold shots , as long as the CSV is not available this system is not good for me. any way , today I connected a pressure tank to the cold line as advised here and it seems...
  10. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    In addition to the existing pump electronic controller , Is it possible to fix a pressure switch that would switch off the pump when pressure reach 60psi ? but connect the circuit at any value less than 60psi when a water tap is open? I am afraid of cycling when i use such switch and that was...
  11. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    Unfortunately the CSV is not available in Egypt or I would have used it long time ago so we have to use the electronic pump controller which is very common here and have replaced the pressure tank and pressure switch
  12. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    Unfortunately the type of controller i use stops the pump when it achieves its max pressure and no flow so I have no control on pressure and it is in my case 80psi How i can calibrate pressure tank to be 80psi? you mean i fill its air content till 80psi ?
  13. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    The flix hose of the water boiler and it was old , but also the check valve of the boiler that has spring released some water jet when pressure increased due to boiler heating water
  14. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    Thank you for your reply but I am 100% sure the controller has stopped the pump , I have pilot lamp in kitchen shows pump is on or off , plus i can hear it when it kickes in or stopped .. so it is NOT that probability
  15. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    I had this system since long time and it was working perfect but this silent mysterious increase in pressure is a new problem! The system does not have expansion tank and never had it in the past should i connect one?! But if i connect one , the pump would work more to fill it till 80psi...
  16. Bob1000

    2 PUMPS FED FROM SAME CITY WATER PIPE !!!

    Dear All My house consists of 4 apartments , ground floor has 0.5 H.P pump feeding it with an electronic pump controller on it other 3 apartments are fed by another 0.75 H.P pump with another pump controller on it Both pumps are fed from the same point which is the city pipe which has very...
  17. Bob1000

    Electronic pump control

    The point is that they make repairs on the pipe line without notice , unless you have dry running protection you may lose the pump if you are not at home to switch it off. I used to have water sensor that is permanently immersed in water and would cut off the pump if there is no water in the...
  18. Bob1000

    Electronic pump control

    The point is that I get city water cut offs often and I discovered that this device has dry run protection , in my old system ( tank and pressure switch) I had to fix a water sensor on the supply pipe and connect it with the pressure switch to cut it off in case no water also another problem...
  19. Bob1000

    Electronic pump control

    I do understand your point of view and agree with it , but what if I added a small pressure tank to the system , say a 5 liter one just to maintain some pressure in the system to have some reasonable pressure at the moment of opening a tap untill the pump starts ., it is very annoying to open...
  20. Bob1000

    Electronic pump control

    [SIZE=5]I wanted to get rid of the pressure tank , pressure squareD switch and fixed that thing in stead , it was supposed to switch the pump on when you open any water faucet , but it was a complete miss , it does not start immediately and it stays on after I close the tap , plus the pressure...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks