I am in the home stretch in setting up a pressure loop, hand held shower head, and above shower head.
The diverter was installed below the valve that turns off the water. I have installed the R11000 rough in upside down since the intake is below (used a tub/shower faucet valve and capped the top). The diagram shows that up is supposed to be up but its installed above the shower valve.
From there I have incoming water that then goes to the three sources. The problem is when I turn on the water it comes out all three. The body jets seem to have the most pressure.
Is there a specific output for the three outgoing lines? Did I put an out as an in? Other than this perplexing situation everything is set up as intended. If anyone sees where i missed a step in my though process let me know. Thanks again!
The diverter was installed below the valve that turns off the water. I have installed the R11000 rough in upside down since the intake is below (used a tub/shower faucet valve and capped the top). The diagram shows that up is supposed to be up but its installed above the shower valve.
From there I have incoming water that then goes to the three sources. The problem is when I turn on the water it comes out all three. The body jets seem to have the most pressure.
Is there a specific output for the three outgoing lines? Did I put an out as an in? Other than this perplexing situation everything is set up as intended. If anyone sees where i missed a step in my though process let me know. Thanks again!