BrendaC
New Member
We bought a house where the previous owner had moved the toilet and covered up the original location with a bathtub. We decided to remove the tub and put the toilet back in the original location.
I researched countless hours...I wanted skirted, elongated bowl with dual flush (or at least 1.28 gpf to be more water efficient). I decided on the Toto Aquia II and ordered it two months ago. Also bought the Washlet B200.
When it arrived my contractor cracked the bowl during installation. The big box store was great and said they would send a replacement bowl for free. They sent the Drake bowl, which I returned and have been waiting for the Aquia bowl.
Yesterday, I finally decided to measure the rough-in. I had measured where the second toilet was and it was 12", so I assumed the original location was 12" also (HUGE mistake, I know).
It turns out we have an 11" in rough-in. From what I can tell, there is no way the Aquia II will fit.
I think the drain is 4" (it kind of tapers down, it is 3" at the narrowest but 4" at the top near the floor) and the water supply is 8" left of center.
I want a toilet that isn't too far from the wall but would like a Toto so I don't have to worry about compatability with the Washlet. Still want skirted and water efficient.
I am so over looking at toilets after dealing with this for two months. Can anyone please tell me what would fit?
Attaching pics, I know it shows about 10.5" to center from the wall but I measured from the baseboard which is 5/8" thick.
Thanks so much for any advice.
Edited to add: it was the contractor who drilled all the holes in the floor (failure to read instructions). The first set he drilled was for the 10" Aquia, so I think we could still use those. I'm wondering if I should just go non-skirted at this point.
I researched countless hours...I wanted skirted, elongated bowl with dual flush (or at least 1.28 gpf to be more water efficient). I decided on the Toto Aquia II and ordered it two months ago. Also bought the Washlet B200.
When it arrived my contractor cracked the bowl during installation. The big box store was great and said they would send a replacement bowl for free. They sent the Drake bowl, which I returned and have been waiting for the Aquia bowl.
Yesterday, I finally decided to measure the rough-in. I had measured where the second toilet was and it was 12", so I assumed the original location was 12" also (HUGE mistake, I know).
It turns out we have an 11" in rough-in. From what I can tell, there is no way the Aquia II will fit.
I think the drain is 4" (it kind of tapers down, it is 3" at the narrowest but 4" at the top near the floor) and the water supply is 8" left of center.
I want a toilet that isn't too far from the wall but would like a Toto so I don't have to worry about compatability with the Washlet. Still want skirted and water efficient.
I am so over looking at toilets after dealing with this for two months. Can anyone please tell me what would fit?
Attaching pics, I know it shows about 10.5" to center from the wall but I measured from the baseboard which is 5/8" thick.
Thanks so much for any advice.
Edited to add: it was the contractor who drilled all the holes in the floor (failure to read instructions). The first set he drilled was for the 10" Aquia, so I think we could still use those. I'm wondering if I should just go non-skirted at this point.