Qwertyjjj
Member
- Messages
- 260
- Reaction score
- 2
- Points
- 18
The ejector pump pumps directly to the septic tank.
After about 1 minute, I can hear some gurgling and it sounds like water coming back through the pipe.
Anything I can do to see what the problem might be?
It's in the pipe closest in the video.
the bizarre thing is that that pipe closest in the picture has a 90 degree bend into the floor again.
I can replace the check valve to test it out.
do i just run the pump cycle then disconnect it then undo the nuts on the pipe?
I hear a water hammer sound when the pump stops so that must be the valve working?
Read more: http://www.doityourself.com/forum/w...er-flowing-back-after-1min.html#ixzz3Aly4h3fm
² - YouTube
1 - YouTube
How do I know if the check valve is ok?
Should I just seal all the joins with silicone or put an acryclic box over the pump and seal it?
After about 1 minute, I can hear some gurgling and it sounds like water coming back through the pipe.
Anything I can do to see what the problem might be?
It's in the pipe closest in the video.
the bizarre thing is that that pipe closest in the picture has a 90 degree bend into the floor again.
I can replace the check valve to test it out.
do i just run the pump cycle then disconnect it then undo the nuts on the pipe?
I hear a water hammer sound when the pump stops so that must be the valve working?
Read more: http://www.doityourself.com/forum/w...er-flowing-back-after-1min.html#ixzz3Aly4h3fm
² - YouTube
1 - YouTube
How do I know if the check valve is ok?
Should I just seal all the joins with silicone or put an acryclic box over the pump and seal it?