Leon82
Member
Ive made my pan liner and want to double check my curb height before I clamp it ti the drain. I feel im good but a second look wont hurt.
Im 3.5 inches above the drain at the bottom and 1.75 above from the back most wall which is the highest. This is a linear drain with the curb at a right angle to it.
The UPC says
Where a shower
receptor has a finished dam, curb, or threshold it shall be not
less than 1 inch (25.4 mm) lower than the sides and back of
such receptor. In no case shall a dam or threshold be less than
2 inches (51 mm) or exceeding 9 inches (229 mm) in depth
where measured from the top of the dam or threshold to the
top of the drain.
I think it says you need a curb >2 inches above the drain and >1 inch above the highest point of the floor, but The first sentence makes me confused.
Thanks
Leon
Im 3.5 inches above the drain at the bottom and 1.75 above from the back most wall which is the highest. This is a linear drain with the curb at a right angle to it.
The UPC says
Where a shower
receptor has a finished dam, curb, or threshold it shall be not
less than 1 inch (25.4 mm) lower than the sides and back of
such receptor. In no case shall a dam or threshold be less than
2 inches (51 mm) or exceeding 9 inches (229 mm) in depth
where measured from the top of the dam or threshold to the
top of the drain.
I think it says you need a curb >2 inches above the drain and >1 inch above the highest point of the floor, but The first sentence makes me confused.
Thanks
Leon
