Recent content by Smithjoey

Thank you very much! I notice one review says once cut down, it doesn’t fit snug. Is there any way to avoid that from happening? In theory if I wanted to use a regular length flange, could I also put a coupling of some sorts onto the elbow hub to basically raise it up? What coupling would that...

That’s what I was suspecting. It seems like an extended 3” spigot flange doesn’t even exist to actually buy from somewhere? Is anyone able to point me to one that I can buy? Or, is there some other solution such as an extension to the elbow hub and then putting a flange into the extension?

The basement is below. I’ve read opinions that the flange should go on top of the finished floor, so when I laid the tile that’s how I had it set up. Are you sure that flange will fit right inside the elbow hub fitting? It seems like there are many flanges labeled to fit inside 3 inch, but are...

Hi everyone, I had a question that I’ve been researching a ton and can’t seem to figure out. Forgive me if any of my terminology is incorrect. I’m redoing a bathroom. Coming up out of the floor is a pvc 3 inch hub x spigot elbow. The “hub” is the part coming up out of the floor. I need a...