Recent content by Greg Wmson

Tenant complains about overflows and standing water in the back bathroom toilet, so I snake out that vent 50' in and it comes out clean with no real blockage, so I snaked out the bathroom in the middle of the house on the other side of the problem bathroom wall and while doing so, I found sand...

I guess the vinegar did the trick, after soaking overnight, and approaching it with a fresh start and a good nights sleep, it slid out with minimal effort and some gentle persuasion. I definitely wanted to change this drain valve, but I just can't see that happening. Now I need to figure out a...

Well crap, after closer inspection, its apparent that the guy did not fill it up with concrete and put a thin layer of rubber on it, but actually filled the entire hole with rubber, probably not rubber but definately oil based, hard, black, and thick, it appears to be about the consistency of...

I've got a drain with a plunger that is completely broke off, It has nothing to hook on and all the linkage has been pulled off, and to replace the assembly would be a tough job, as its buried under concrete and somewhat risky as the water supply lines are less than an inch away from where I...

Just wanted to follow up and say, Thanks everyone so much, I did just that and its working fine now. I checked my voltages off and on throughout the day and the explanation you gave, my voltmeter and the scalding hot water told me everything was working perfectly now.. Again, Thank you very much.

I'm looking at this.. And mine is wired like this. It appears my T2 and T4 are reversed. Would this cause my thermostat to stop working? Have I damaged my thermostat or will reversing the wires fix my problems? Was concerned because this new thermostat was not exactly like the original...