Recent content by DanW

Thanks I should have known better than to look at what those bozo builders did, thinking that was the way it should be done. I'm off to lowes.

Oh now you're talking! I'd cut the whole damn glued up thing off at the first elbow. Put that puppy on the straight pipe that's left, cut accordingly. Rotate to the right position and tighten it up.

Two sounds like the easiest! I'm not really averse to redoing the pvc. My only issue is how to cut it. The p trap is close to the wall and in terms of alignment with sink hole front to back its fine. First pic is left to right. Second pic is front to back. Third pic is the whole thing.

The photo from above shows the amount of offset. The tail pipe is not installed in the sink. It is just the hole looking down at the drain pipe below from directly above. You can see the plastic compression nut of the drain pipe. That's how little it is off. I'll take a pic from underneath. I...

Hi, I'm just wondering if the attached picture of the alignment is fine. I'm sure I can get the tail pipe on the new sink into the existing drain pipe, but the alignment is slightly off. There will be a little tension on the tail pipe. Total newb so maybe this is obvious. But is this ok?

I had this same problem. The clunking was so loud, you could feel the vibration downstairs. Replacing the cartridge completely eliminated it.

I have a Symmons Temptrol shower control. I've noticed over the past several months that, if the valve is turned on slowly (I believe this happens regardless of which position the diverter is in), an extremely loud clicking/banging comes from the control. But if left in that position, it...