Recent content by boardable

The putty is only on the inside and to "aid" in any deformity in the cast. Terry I go with you, probably the wrong coupler.

This is most likely PEX. Look it up. A very neat set up. I prefer copper but most likely the previous owner had a re pipe done in PEX for cost.

Dreqw, first think is make sure your connector is CI to Plastic. If not it will leak. The fact that it leaks when it rains means that you did not water test it so I am assuming you are doing this without permits. What you need to do is make sure you have the correct no hubs and if there is still...

Yes but I see only small diverter trim not large diverter trim. Just goes along with my complaints of no 45 degree kerdi corners LOL.

Update. So last night I took the pfister trim off of my bath tub and the trim fits with the delta pieces. I will now call Kerdi to ask them why they don't make a diverter trim seal.

I was almost thinking about the pfister the other day.

Yes it keeps it simple but functional.

If they make a extension i could use that and then use a standard delta back plate.

You are correct.

The model is the delta linden. But I looked at all the delta valve trims just to see if I could get a repair part and none will fit. I even paid a extra 40 bucks and ordered the vintage look trim to take up more room and still there is a little gap to be seen.

Jad, that is all done. I used the mixing valve seal which is a seal that you put on that basically insures any water that leaks in comes back out and never gets behind the wall. It is a essential part of the kerdi system. That is why the hole is so big. So to simplify it let's just say the hole...

Ok so here is the deal. Got a delta diverter valve with trim. When I installed with the kerdi the only mixing valve seal available was the standard 4 inch. but the trim ring for the diverter valve is smaller. I need a larger trim to cover it preferably one that is 5.5 " Any ideas.

Because he is a pro. He is clean with his thinset. Me on the other hand. It looks like it sneezed thinset all over hahaha.

Yes. Delta makes one. The line is carlisle. Check it out . Ihave one in my shower. You will love it. Just google Search delta Carlisle

22000 seems a bit high but it depends on what you want. I usually am about 13k fora 5x8 bathroom and that includes full gut, some moldy 2x4's and possibly some floor boards, Heated floors, mid line fixtures aka shower and diverter such as a delta up to 300.00. Kerdi system, tile priced at 8 a...